hoverboard-firmware-hack-se.../README.md

31 lines
1.7 KiB
Markdown

# New Firmware! Now with actual current sensing!
This firmware is much better than the old one. tested up to 40A / 60V, no dead board so far :)
## Hoverboard-Board-Hack
This repo contains open source firmware for generic Hoverboard Mainboards.
The firmware you can find here allows you to use your Hoverboard Hardware (like the Mainboard, Motors and Battery) for cool projects like driving armchairs, person-tracking transportation robots and every other application you can imagine that requires controlling the Motors.
---
#### Hardware
![otter](https://raw.githubusercontent.com/NiklasFauth/Hoverboard-Board-Hack/master/schema.jpg)
The original Hardware supports two 4-pin cables that originally were connected to the two sensor boards. They break out GND, 12/15V and USART2&3 of the Hoverboard mainboard.
Both USART2 & 3 can be used for UART and I2C, PA2&3 can be used as 12bit ADCs.
---
#### Flashing
To build the firmware, just type "make". Make sure you have specified your gcc-arm-none-eabi binary location in the Makefile. Right to the STM32, there is a debugging header with GND, 3V3, SWDIO and SWCLK. Connect these to your SWD programmer, like the ST-Link found on many STM devboards.
Make sure you hold the powerbutton or connect a jumper to the power button pins while flashing the firmware, as the STM might release the power latch and switches itself off during flashing.
---
#### Examples
Have a looh at the config.h in the Inc directory. That's where you configure to firmware to match your project.
Currently supported: Wii Nunchuck, analog potentiometer and PPM signal from a RC remote.
If you need additional features like a boost button, have a look at the while(1) loop in the main.c