89 lines
2.3 KiB
C
89 lines
2.3 KiB
C
|
|
#include "stm32f1xx_hal.h"
|
|
#include "defines.h"
|
|
#include "setup.h"
|
|
#include "config.h"
|
|
|
|
TIM_HandleTypeDef TimHandle;
|
|
uint8_t ppm_count = 0;
|
|
uint32_t timeout = 100;
|
|
uint8_t nunchuck_data[6] = {0};
|
|
|
|
uint8_t ai2cBuffer[6];
|
|
|
|
extern I2C_HandleTypeDef hi2c2;
|
|
DMA_HandleTypeDef hdma_i2c2_rx;
|
|
DMA_HandleTypeDef hdma_i2c2_tx;
|
|
|
|
#ifdef CONTROL_PPM
|
|
uint16_t ppm_captured_value[PPM_NUM_CHANNELS+1] = {0};
|
|
|
|
void PPM_ISR_Callback() {
|
|
// Dummy loop with 16 bit count wrap around
|
|
uint16_t rc_delay = TIM2->CNT;
|
|
TIM2->CNT = 0;
|
|
|
|
if (rc_delay > 3000) {
|
|
ppm_count = 0;
|
|
}
|
|
else if (ppm_count < PPM_NUM_CHANNELS){
|
|
timeout = 0;
|
|
ppm_captured_value[ppm_count] = CLAMP(rc_delay, 1000, 2000) - 1000;
|
|
ppm_count++;
|
|
}
|
|
|
|
}
|
|
|
|
void PPM_Init() {
|
|
GPIO_InitTypeDef GPIO_InitStruct;
|
|
/*Configure GPIO pin : PA3 */
|
|
GPIO_InitStruct.Pin = GPIO_PIN_3;
|
|
GPIO_InitStruct.Mode = GPIO_MODE_IT_FALLING;
|
|
GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_HIGH;
|
|
GPIO_InitStruct.Pull = GPIO_PULLDOWN;
|
|
HAL_GPIO_Init(GPIOA, &GPIO_InitStruct);
|
|
|
|
__HAL_RCC_TIM2_CLK_ENABLE();
|
|
TimHandle.Instance = TIM2;
|
|
TimHandle.Init.Period = UINT16_MAX;
|
|
TimHandle.Init.Prescaler = (SystemCoreClock/DELAY_TIM_FREQUENCY_US)-1;;
|
|
TimHandle.Init.ClockDivision = 0;
|
|
TimHandle.Init.CounterMode = TIM_COUNTERMODE_UP;
|
|
HAL_TIM_Base_Init(&TimHandle);
|
|
|
|
/* EXTI interrupt init*/
|
|
HAL_NVIC_SetPriority(EXTI3_IRQn, 0, 0);
|
|
HAL_NVIC_EnableIRQ(EXTI3_IRQn);
|
|
HAL_TIM_Base_Start(&TimHandle);
|
|
}
|
|
#endif
|
|
|
|
void Nunchuck_Init() {
|
|
//-- START -- init WiiNunchuck
|
|
ai2cBuffer[0] = 0xF0;
|
|
ai2cBuffer[1] = 0x55;
|
|
//Originale
|
|
ai2cBuffer[0] = 0x40;
|
|
ai2cBuffer[1] = 0x00;
|
|
//HAL_I2C_Master_Transmit_DMA(&hi2c2, 0xA4, (uint8_t*)ai2cBuffer, 2);
|
|
//while(wii_JOYdati.I2CTxDone ==0);
|
|
//wii_JOYdati.I2CTxDone = 0;
|
|
HAL_I2C_Master_Transmit(&hi2c2,0xA4,(uint8_t*)ai2cBuffer, 2, 100);
|
|
HAL_Delay(10);
|
|
//wii_JOYdati.done = 0;
|
|
}
|
|
|
|
void Nunchuck_Read() {
|
|
ai2cBuffer[0] = 0x00;
|
|
HAL_I2C_Master_Transmit(&hi2c2,0xA4,(uint8_t*)ai2cBuffer, 1, 100);
|
|
HAL_Delay(2);
|
|
HAL_I2C_Master_Receive(&hi2c2,0xA4,(uint8_t*)ai2cBuffer, 6, 100);
|
|
for (int i = 0; i < 6; i++) {
|
|
nunchuck_data[i] = (ai2cBuffer[i] ^ 0x17) + 0x17;
|
|
}
|
|
//setScopeChannel(0, (int)nunchuck_data[0]);
|
|
//setScopeChannel(1, (int)nunchuck_data[1]);
|
|
//setScopeChannel(2, (int)nunchuck_data[5] & 1);
|
|
//setScopeChannel(3, ((int)nunchuck_data[5] >> 1) & 1);
|
|
}
|